Sandwich Panel Roll Forming Machine, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel machine

Sandwich panel creation line is specially developed for creating insulation composite board. With stepless speed regulation technique, it is in a position to make corrugated composite panel successfully at one time. Sandwich panel roll forming machine has been an indispensable system in fabricating roof panels and wall panels in plants and warehouses, amongst other buildings.

Attributes

one. The motor electrical power of the sandwich panel roll forming line is 4kw, and the creation speed reaches 6m/min. With the stepless speed regulation technique, the performance of the roll forming line is optional inside of -6m/min.

2. When generating EPS sandwich panel, the pace is normally controlled at 2-6 m/min. It will be a bit lower for producing rock wool board (relies upon on genuine demands)

3. The composite panel generation line is equipped with K-nine glue metering pump, featuring lower rotating pace and high accuracy. The glue is fed at a price of .one-2. kg/min. It is controlled by frequency converter.

4. The thickness of the composite panel the roll forming unit can generate is varied from 50mm to 250mm. By adjusting the higher and decrease rack, and the distance among the cutter holder and the content feeding rack, we can get sandwich boards with different thickness and specifications.

five. Complete put in capability: 34KW complete weight (like add-ons): seventeen.5t.

6. Dimension of the panel roll forming device: 12500 (16000 for rock wool boards) X2200X2800 the roll former for five variety EPS sandwich panel adopts 23 rubber shafts and 160X80 square tubes with thickness of 6mm the roll previous for seven type composite rock wool panel employs 45 rubber shafts, and higher and reduce independent glue source. It is equipped with one.7m rock wool panel conveyor belt, with the diameter of the drive shaft to be 50mm duration of the equipment body is up to 9m the roll previous is welded with 180X80 sq. tubes which thickness is 8mm.

Needs for Factories:

The factories exactly where our EPS sandwich panel manufacturing line are applied can be either flatroof or sloped-roof sort. The top of the cornice ought to be greater than 5m, and the successful width ought to be at least 45m. The flooring of the manufacturing facility should be flat and concrete. For foundation of the roll forming line, it is needed to be to be 380V, and the whole put in electrical power is 34kw. It is required for the manufacturing facility to be geared up with .four-.6MPa compressed air supply and illumination gadgets. The roll forming machine shares the same energy provide with the auxiliary products. The fluctuation of voltage should be no more than ten%, or it may direct to an irregular managing of the program.

Leave a Reply

Your email address will not be published. Required fields are marked *