Sandwich Panel Roll Forming Equipment, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel production line

Sandwich panel generation line is particularly designed for producing insulation composite board. With stepless pace regulation technique, it is ready to create corrugated composite panel effectively at one time. Sandwich panel roll forming equipment has been an indispensable gadget in fabricating roof panels and wall panels in crops and warehouses, among other buildings.

Characteristics

one. The motor power of the sandwich panel roll forming line is 4kw, and the manufacturing velocity reaches 6m/min. With the stepless pace regulation method, the performance of the roll forming line is optional inside of -6m/min.

2. When producing EPS sandwich panel, the velocity is usually managed at 2-six m/min. It will be a bit decrease for generating rock wool board (relies upon on genuine wants)

3. The composite panel manufacturing line is equipped with K-9 glue metering pump, that includes minimal rotating pace and high precision. The glue is fed at a fee of .one-two. kg/min. It is managed by frequency converter.

four. The thickness of the composite panel the roll forming device can produce is varied from 50mm to 250mm. By altering the higher and reduced rack, and the length between the cutter holder and the content feeding rack, we can get sandwich boards with various thickness and specs.

five. Complete installed potential: 34KW overall fat (like accessories): seventeen.5t.

six. Dimension of the panel roll forming equipment: 12500 (16000 for rock wool boards) X2200X2800 the roll previous for 5 variety EPS sandwich panel adopts 23 rubber shafts and 160X80 square tubes with thickness of 6mm the roll former for 7 variety composite rock wool panel employs 45 rubber shafts, and upper and decrease independent glue provide. It is geared up with one.7m rock wool panel conveyor belt, with the diameter of the push shaft to be 50mm duration of the equipment frame is up to 9m the roll previous is welded with 180X80 square tubes which thickness is 8mm.

Demands for Factories:

The factories where our EPS sandwich panel manufacturing line are utilized can be both flatroof or sloped-roof type. The height of the cornice should be greater than 5m, and the effective width must be at minimum 45m. The ground of the manufacturing facility ought to be flat and concrete. For basis of the roll forming line, it is needed to be to be 380V, and the total installed electrical power is 34kw. It is required for the manufacturing unit to be geared up with .4-.6MPa compressed air source and illumination units. The roll forming device shares the exact same energy supply with the auxiliary products. The fluctuation of voltage should be no far more than 10%, or it could direct to an irregular managing of the system.

Leave a Reply

Your email address will not be published. Required fields are marked *